This is the big sister to the MTR-3.0, the perfect frame for a light weight and ballistic freestyle setup. A favorite combination of many pilots is however 1804/2800kv motors - 20a ESCs - 4s/850 battery and T3045 DAL bullnose props. It can of course be set up mild or wild depending on the selection of motor and battery. This a 154mm size main frame cut from 3mm Carbon with motor hole patterns specifically made for the 1800 sized motors and 3 inch props (hence the name MTR-3.0). It is a great size for flying in a smaller space, but will still keep up with your buddy’s bigger machines. This little pocket rocket is for those that want the most performance in the smallest package. The original design size and the one that all the testing was done on. The MTR Race Quads were specifically designed around the ReadyMadeRC Dodo Board, mating PDB, Tramp HV video transmitter, Spektrum FPV Serial Receiver and 1177 style/size FPV camera. In some cases you would also want to change motor and esc size. Each frame has the exact same center section/pod for the electronics, so if you do decide to try a different size at some point, all that would be needed is to adjust the length of the motor/esc wires. There are four MTR Race Quad frame sizes to choose from based on your flying goal and race objectives. Smaller cameras, slim video transmitters, super small ESCs and Flight Controllers with piggybacked or built in PDBs all allow for a more compact electronics bundle that fits nicely between the 25mm deck spacing of the main frame and upper deck. The MTR line of race quads was designed around some of the new smaller tech that the race quads require. Manutech Racing – MTR Line of Race Spec Quadcopters
0 Comments
Leave a Reply. |